Waiting.
Below 100% the other two channels are mixed in, so the strip washes out towards white.
Following the white at -.
Shifts timers marked "random" by up to 15 minutes each day so the lamp does not look automated.
--Hold the pad until the strip pulses green, between three and five seconds, let go, then tap three times to send. Any tap clears an alarm at either end.
Scenes on the light tab
Drag to reorder. Anything below the line stays off the light tab.
Effects on the light tab
Same again. The pad's triple tap walks the visible scenes in this order.
-Scanning…
Access
On the home network the code keeps the household out of the settings. It is a latch, not security: four digits over plain HTTP, and the firmware carries recovery codes. Remote access always asks for it, and the recovery codes do not work from outside.